Bodybuilding DVD's

Ronnie Coleman

Colossal Workout
Dennis Wolf

Dorian Yates

Believe to Achieve
Jay Cutler's house

Hard and Heavy

Making Testosterone Cypionate

Click on any picture for the larger one.

Test Cypionate 10 gram conversion

Needed:
10 grams Test Cypionate
Magic Solution
40ml Sterile Oil
Syringes 3cc & 5/10cc
2 - 18 or 20 guage needles
50ml Vial
50ml Sterile Vial
Whatman sterile filter

step 1

A. Weigh out 10 grams of powder.
B. Place powder in vial.
C. Add 5mls of "Magic Solution" to the vial.

Step 2

Swirl the mix of solution and powder around in the vial.
A glass stir rod is very good to have for this though it is not nessasary.

Step 3
A. Heat a pan or pot of water just to the point where it starts to boil then pull it off and onto a burner heat is off.

B. Then place the vial into the water and let it sit for about 10-15 minutes. Give it a swirl and or stir with the glass rod to help it melt in the solution.

Step 4

Add 35mls of oil to the solution. You can use a funnel as shown.

*** Note: To sterilize the funnel you can wash it well and let it air dry. Then run some Methyl Alcohol through it and let it dry again.

Step 5

You will want to re-heat the water to boiling point again as you will be letting it sit in it again.

Step 6

At this point you can placea stopper on the vial and shake it well. Then place it in the bath of hot water for approx 15 minutes.

***Note: it may take some time for it to fully suspend and may look grainy but it will suspend... it just takes a little time.

Step 7

Here you can see it is suspended well and is nice and clear and ready to be filtered.

Step 8

This set-up will look familiar to those who have make Fina.

The set-up is a sterile vial that is vented and the whatmen filter attached to an 18 guage pin.

You will draw from the vial and then cover the pin and detach it from the syringe. Then re-attach the syringe to the whatman filter that stays attached to the vial.
Slow and steady you will push the product through the filter using the 10ml. syringe.

You will do this till all the product is filtered AND keeping track of how many mls you push through.

You will want to even it out in the end and purge the filter with whatever amount of sterile oil is nessesary to make it 50mls. This will also get all the remaining product flushed out of the filter.

You final product will be a painless 200mg/ml @ 50mls of Test Cyp.

If you use an article from this site, Please consider a link back to WWW.BASSKILLERONLINE.COM if possible.. Thank you kindly

Come join us at the hottest Bodybuilding steroid board around
Free to join!!!!
World class bodybuilding